PhytoSim Calibration Change Log

Version 1.2.2

Fixed GUI slow-down when plotting many infinite objective values on the 'Objective Value vs. Evaluation Number' graph.

Confidence information calculations: estimation errors and correlation matrix.
Added the 'Single shot' optimizer: evaluate the objective at the initial values.
Zooming is now allowed on all graphs.
'Best' simulation curve now has a +/- 2*stdev measurement uncertainty band on it.
Minimum and maximum graph marker lines for optimizer variables.
New example: HydR, linking diameter changes to radial water transport across a radial hydraulic resistance (Steppe et al., 2011). Only available for non-trial accounts.

Fixed title of the 'To simulation' dialog box.
Added a bounds check for the optimizer variable initial values.
Simulations that terminate prematurely don't count when calculating the objective value.

Better error messages when input data has been removed.
Problem with copying best values to the simulation.
Problem with 'ghost' optimizer and objective variables (caused when removing a model component that was used in a calibration).

Unit conversion problem when changing an input independent variable unit.
External data simulation curve F_stem_data did not point to the correct data input column.

The simulation start and stop values determine which part of the calibration data is shown.

New example: RCGro2, water transport and storage model (De Pauw et al., 2008).
New example: Staci, model of the Software Tool for Automatic Control of Irrigation (Steppe et al., 2008).
New example: ZweifelPotentialTranspiration (Zweifel et al., 2002), calibration using a custom objective for a 30-day data set of an oak tree.

Rescaling issue on objective graph for multiple objective variable contributions.

News